Inventor General Discussion

Reply
*Expert Elite*
JDMather
Posts: 26,359
Registered: ‎04-20-2006
Message 11 of 13 (82 Views)

Re: Flattening a 3D solid

01-24-2013 08:12 AM in reply to: amber_troyer

amber_troyer wrote:

 I am "attempting" to draw a column for a water tower.

This is the piece that meets the base of the container.


 

This sounds like two different pieces to me?  (based on the files you attached)
Are you really trying to draw the column as it meets the base of the container, or are you trying to draw a piece that goes in between the column and the container.

 

When I get a chance - I will post a new file of what I interpret the problem to now be.

If you have any more information - be sure to supply it.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
JDMather
Posts: 26,359
Registered: ‎04-20-2006
Message 12 of 13 (74 Views)

Re: Flattening a 3D solid

01-24-2013 08:27 AM in reply to: JDMather

I just realized that I made a mistake in my original solution.

But given the additional information I need to start over anyhow.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
amber_troyer
Posts: 7
Registered: ‎02-03-2011
Message 13 of 13 (66 Views)

Re: Flattening a 3D solid

01-24-2013 09:51 AM in reply to: amber_troyer

Yes, they should be two separate pieces. I guess that is what I was trying to do with the revolved piece, sort of cut out what I need and get rid of the rest. I did draw my column straight, but I angled the centerline of where the tank should be, which is where I took my measurements from. I have attached the dwg. Thank you so much for your help and patience with me. This is the first time I have drawn something like this in inventor.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube