Drawing angle use quadrant by default

[z.baczo]

Hello everyone,

Is there a way to make the "Use Quadrant" option by default when placing andular dimensions in drawings (instead of right-clicking-->Options-->Use Quadrant (see attached) every single time I place an angular dimension)?

I'm sure it's possible, I just can't find the option to do that...

Thanks in advance,

B.

[Nicolas.Bourquin · Accepted solution]

Hi Z.baczo,

Probably what you are looking for can be set in the dimension style as indicated in the picture here below.

Note 1: to enable this change for all the future drawings, you could make this modification directly in the dimension style of your template(s).

Note 2: it is also possible to save this change in the "style library" as indicated in the second picture here below..

I hope that can help you.

Best Regards.

[z.baczo]

Hello Nicolas Bourquin,

This is exactly what i was looking for. Thanks!

[tatianakantsurova]

2023 Inventor - quadrant default option is not working.

[johnsonshiue]

Hi Tatiana,

I cannot seem to reproduce the "Use Quadrant" issue on 2023.3.1 update. If possible, please share the file that exhibits the defective behavior.

Many thanks!