Dimensioning pre-radius

[Anonymous]

I have two parts coming together at a 20 degree angle. The corner has a 3/4" radius applied to it. I need to be able to dimension to the corner before the radius was applied. However, I have to show it with the radius.

How do i extend lines out to a cross so that I can dimension to the true corner?

[Anonymous]

http://www.kwikmcad.com/iclips/avi/intersection.zip -- Sean Dotson, PE (AICE) RND Automation & Engineering sdotson.com mcadforums.com "kellyhoyer" wrote in message news:17472546.1110309638680.JavaMail.jive@jiveforum1.autodesk.com... > I have two parts coming together at a 20 degree angle. The corner has a 3/4" radius applied to it. I need to be able to dimension to the corner before the radius was applied. However, I have to show it with the radius. > > How do i extend lines out to a cross so that I can dimension to the true corner?

[Anonymous]

Create a sketch.

[Anonymous]

Sorry. I understood it as you wanting to show cut stock.
See Sean's post.

[Anonymous]

Once again, thank you.
Sean

Your awsome.