Inventor General Discussion

Active Member
Posts: 10
Registered: ‎12-20-2012
Message 1 of 2 (229 Views)
Accepted Solution

Dimensioning issues

229 Views, 1 Replies
12-20-2012 05:19 AM

in circle one i have to dimension from the edge of the object ot the closest side of the middle dividing piece, but pecause the points are slightly offset i cannot get the true dimension.

In circle two i have to add more dimensions on the back view of the object but because of the required view i cannot accurately dimension the object


Valued Mentor
Posts: 322
Registered: ‎02-06-2004
Message 2 of 2 (216 Views)

Re: Dimensioning issues

12-20-2012 05:27 AM in reply to: Jatomz616

Why not make an isometric view of that section?

Inventor 2013

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor