Inventor General Discussion

Inventor General Discussion

Posts: 23
Registered: ‎02-21-2008
Message 1 of 2 (98 Views)

Designating a folder for Design Data

98 Views, 1 Replies
06-10-2009 07:13 AM
I recently installed Inventor 2010 Pro and am in the process of configuring it. I have not been able to set the default folder for the Design Data on the Application Options/File tab. When I browse to the folder and Apply the change, I get a message saying that the current project must be closed and reloaded for the change to take affect. The field indicates the correct location for the Design Data, but when I close and reload the project, the Design Data location on the Application Options/File tab reverts back to the location set during installation. I have successfully changed the location of the Templates, Content Center, and Projects folders without issue. I didn't have any problems doing this with Inventor 2009.

Any suggestions would be appreciated. Thanks.
Posts: 200
Registered: ‎06-25-2009
Message 2 of 2 (98 Views)

Re: Designating a folder for Design Data

09-17-2009 03:44 AM in reply to: gordow
See here:畊
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.