Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
gavin.b
Posts: 54
Registered: ‎12-07-2011
Message 11 of 11 (102 Views)

Re: Derived & mirrored sheet metal parts - application settings question

10-17-2012 05:42 PM in reply to: llorden4

I've realised that my previous post is actually not quite correct. Because the mirrored sheetmetal part is actually derived from the original sheetmetal part, it will actually use the original part's thickness to control it's geometry, not the sheetmetal style. Changing the style in the original part (and therefore the thickness) will also change the mirrored component. I still believe however, that the style of the mirrored part should match the original automatically to allow unfolding.

A poor workman blames his tools
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.