Inventor General Discussion

Message 1 of 2 (299 Views)

Cross-bending on plate?

299 Views, 1 Replies
11-05-2002 06:18 PM
Is it possible to make a cross-bend on a plate ex. 2 x 1.5 deg?

*Keller, Kent
Message 2 of 2 (299 Views)

Re: Cross-bending on plate?

11-06-2002 12:57 AM in reply to: *Joanne
There have been at least one method posted to customer files in the past. If I remember
right it was done with a shell and a face split but not positive.

Have you tired doing some searching in the old Newsgroup?

Member of the Autodesk Discussion Forum Moderator Program

"Joanne" wrote in message news:f1203d3.-1@WebX.maYIadrTaRb...
> Is it possible to make a cross-bend on a plate ex. 2 x 1.5 deg?
> J

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor