Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
There has been a few references here about the relative merits of iParts vs.
library parts. Anyone want to elaborate on the rational behind this
(hopefully, briefly).
Maybe my second question answers the first:
I insert a library part (finally figured out how, bit dense sometimes), say
a 1/4-20 nut.
Oops, should have been a 1/4-28. How do I change it? I know I can replace it
but that seems a bit cumbersome. Should be easier but I can't figure out
how.
Ray
With iParts just select the flat head factory part.
Lester Martin wrote:
> How do you change from a Hex head Bolt to a Flat head.
>
>
> "Kent Keller" wrote in message
> news:DC9EA8E68C04B4E79B29667242E73FE2@in.WebX.maYIadrTaRb...
>
>>Select one
>>Edit >>Replace All
>>Browse to the same Parent they are made from, and then in the iPart dialog
>
> select a
>
>>different size.
>>
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")