Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
vmcarbonneau
Posts: 37
Registered: ‎06-01-2012
Message 1 of 1 (88 Views)

Cable & harness, different pin directions

88 Views, 0 Replies
11-08-2012 01:02 PM

I am starting to use cable & harness with IV 2013. I found out how to define the direction of the cable on a connector.

 

The problem I have is that a there is only one possible direction that can be defined. I have connectors with pins that exits with different directions. Is there a way to define more than one direction ?

 

Ty

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.