Inventor General Discussion

Active Contributor
Posts: 37
Registered: ‎06-01-2012
Message 1 of 1 (85 Views)

Cable & harness, different pin directions

85 Views, 0 Replies
11-08-2012 01:02 PM

I am starting to use cable & harness with IV 2013. I found out how to define the direction of the cable on a connector.


The problem I have is that a there is only one possible direction that can be defined. I have connectors with pins that exits with different directions. Is there a way to define more than one direction ?



You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor