Inventor General Discussion

Reply
Contributor
johnny01
Posts: 23
Registered: ‎12-15-2008
Message 1 of 5 (141 Views)

Break out view of section view

141 Views, 4 Replies
08-31-2009 09:52 AM
Is it possible to do a break out view of a section view? I'm trying to do this in IV 2009 and after the command completes, my view is left the same.
Distinguished Contributor
msklein
Posts: 1,451
Registered: ‎12-12-2003
Message 2 of 5 (141 Views)

Re: Break out view of section view

08-31-2009 12:29 PM in reply to: johnny01
check to make sure where your sketch is, it maynot be in the view you wanted it in. It is best to highlight the view you want in the tree then pick sketch to make sure.
msk
Contributor
johnny01
Posts: 23
Registered: ‎12-15-2008
Message 3 of 5 (141 Views)

Re: Break out view of section view

08-31-2009 01:41 PM in reply to: johnny01
That's how I always do it so that is not the problem, but thanks.
*Peer Hoffmann
Message 4 of 5 (141 Views)

Re: Break out view of section view

09-01-2009 02:29 AM in reply to: johnny01
Remembered to add a depth value?

Works fine here.

--

Peer
Iv2009 Sp2/Iv2010 Sp1
Lenovo ThinkStation S10
Intel Core 2 Quad - 2.66GHZ
4GB RAM - WinXPSp3/32Bit
Samsung SyncMaster 244T 24" 1920 x 1200
nVidia Quadro FX1700 - 512MB 6.14.11.8246
3Dconnexion SpaceNavigator 3.6.7
Distinguished Contributor
msklein
Posts: 1,451
Registered: ‎12-12-2003
Message 5 of 5 (141 Views)

Re: Break out view of section view

09-01-2009 07:34 AM in reply to: johnny01

Peer,
I've had the same problem every once in a while, sometimes it's that i didn't get the sketch in the correct view. A couple of times the view didn't show up but when i turned on the view and scale nomenclature that showed up and then i could find the empty view box. It could be i can't remember that i got an error message about no edge found.
msk

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube