Inventor General Discussion

Reply
Valued Mentor
Ktelang
Posts: 287
Registered: ‎09-23-2010
Message 1 of 4 (246 Views)

Break View at an Angle

246 Views, 3 Replies
06-25-2012 11:51 AM

Hello Everyone,

 

Any trick to make create a break view along a sloping edge.

So that the view still appears continuous rather that the one

shown in attached pic.

Thanks

 

------------------------------------------------------------------------------
Config :: Intel (R) Xeon (R) CPU E31245 @ 3.30 GHz, 16.0 GB, 64bit win7
Inventor 2013 and Vault Basic 2013
-----------------------------------------------------------------------------
*Expert Elite*
Curtis_Waguespack
Posts: 2,811
Registered: ‎03-08-2006
Message 2 of 4 (236 Views)

Re: Break View at an Angle

06-25-2012 01:05 PM in reply to: Ktelang

Hi Ktelang, 

 

Unfortunately it isn't possible, but it has been requested in the past. You can add your feedback at the Autodesk feedback link:

 

You can request enhancement and new features using the Feed Back link:
http://inventortrenches.blogspot.com/2011/01/feature-request-for-inventor.html

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Valued Mentor
Ktelang
Posts: 287
Registered: ‎09-23-2010
Message 3 of 4 (230 Views)

Re: Break View at an Angle

06-25-2012 01:48 PM in reply to: Curtis_Waguespack

Thanks Curtis

 

------------------------------------------------------------------------------
Config :: Intel (R) Xeon (R) CPU E31245 @ 3.30 GHz, 16.0 GB, 64bit win7
Inventor 2013 and Vault Basic 2013
-----------------------------------------------------------------------------
New Member
mechdsn
Posts: 1
Registered: ‎10-27-2011
Message 4 of 4 (152 Views)

Re: Break View at an Angle

01-14-2013 10:29 AM in reply to: Ktelang

A possible "work-around" would be to break the views alignment to its parent view and then rotate the view to a horizontal or vertical orientation. Then, you can use the break view command as normal and add the angle of rotation to the view label that was generated automatically. I would typicallly add something like "VIEW ROTATED 60 CCW" (counter clockwise). Most shops can work with that without too much confusion. It would be great if Autodesk would allow broken angled views in the next release though...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube