Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Bent tabs on radius using sheet metal

2 REPLIES 2
Reply
Message 1 of 3
toddg01
348 Views, 2 Replies

Bent tabs on radius using sheet metal

Is there a way to form tabs along a celendrical surface? We are trying to make a bottom of a round basket and we are trying to use the sheet metal portion of Inventor so we could create a flat layout but I can not seem to use an arch as a bendline. Is this the case? We are using IV 2011.

 

 

2 REPLIES 2
Message 2 of 3
JDMather
in reply to: toddg01

Rolled Contour - a search here of the past couple of weeks should turn up example.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 3 of 3
toddg01
in reply to: JDMather

Thanks. I will look into it. I was unsure where to even begin.

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report