Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

BOM Properties dialog box pops up whenever I create a balloon

0 REPLIES 0
Reply
Message 1 of 1
SMGordon
178 Views, 0 Replies

BOM Properties dialog box pops up whenever I create a balloon

I can't figure out why this sometimes happens and sometimes doesn't when I set up a drawing.

 

After setting up the drawing views and placing a parts list into the sheet I start the balloon command and click a part I want to attach a balloon to. Normally I should be able to then place the balloon but sometimes when I create a drawing a 'BOM Properties' dialog box pops up and I have to click the OK button before placing the balloon. For EVERY BALLOON. This is of course extremely annoying and time consuming for an assembly drawing with a lot of parts to balloon.

 

Any insight?

0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report