Inventor General Discussion

Inventor General Discussion

Reply
New Member
Keyser01
Posts: 1
Registered: ‎01-07-2013
Message 1 of 1 (78 Views)

Assembly and iPartproblem with iLogic

78 Views, 0 Replies
01-07-2013 03:43 AM

Hi!

 

I have made an iPart with an internal iLogic Rule
 with an IF statement

 

It works great but not in an assembly

 

The ipart works but not the iLogic rule in the assembly

 

Can i write a simple if statement in the parameters?

 

The rule looks like this

 

If Check > 1 Then
    Angel = 1
Else
    Angel = Check
End If

 

Hope someone can help me out!

 

EDIT: Using Inventor 2012

 

Kind regards

 

Stefan

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.