Inventor General Discussion

New Member
Posts: 2
Registered: ‎11-11-2002
Message 1 of 1 (42 Views)

Assemblies controlled with excel sheets

42 Views, 0 Replies
11-07-2002 08:53 PM
I am working in a smal manufacturing company which makes flow measurement equipment. The products are based on a standard but they are also made according to the customers wishes. The assemblies are built with a flow measuring device made according to the flow. On this part minimum two pressure tappings are mounted.
These pressure tappings vary in sizes, they also different thread size and even some have butt weld and socket weld ends. In some cases valves are mounted on as well.

I can do all the above mentioned things with MDT with a single excel sheet.

Are there any way to do similar things in Inventor?

Best regards


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor