Hello All,
Is it possible to have the area in sq. ft of a part (not sheet metal) in a drawing BOM? I have a model (shelled box minus the top basically) and I just need the total area of the part to show the area of board insulation in an assembly. [Area / 144 / thickness of board insulation] is basically what I need. If so how? If not why?
Tim,
I basically had the same problem and found a solution that may give you some insite as well as a procedure on how to populate the iProperties.
Since this is not a sheet metal part I would use the bounding dimenstions of Length, Width and Heigth. Then find the parameter for the "Shell", from there you should be able to figure the Inside Area and using my solution you may be able to get what you need
Thanks
Can't find what you're looking for? Ask the community or share your knowledge.