Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
shastu
Posts: 1,802
Registered: ‎12-10-2003
Message 1 of 5 (509 Views)
Accepted Solution

Alternate Units on Hole notes.

509 Views, 4 Replies
10-25-2012 12:29 PM

I am using 2012 SP2 and when I try to place hole notes with both metric and inches it only gives me inches (in both displays)  See screen shot. 

*Pro
sbixler
Posts: 1,879
Registered: ‎09-15-2003
Message 2 of 5 (484 Views)

Re: Alternate Units on Hole notes.

10-26-2012 04:21 AM in reply to: shastu

Post screen shots of the dimension style showing the Alternate Units tab, and the Notes and Leaders tab (with the appropriate type of hole note selected).

Distinguished Contributor
shastu
Posts: 1,802
Registered: ‎12-10-2003
Message 3 of 5 (466 Views)

Re: Alternate Units on Hole notes.

10-26-2012 06:06 AM in reply to: shastu
*Pro
sbixler
Posts: 1,879
Registered: ‎09-15-2003
Message 4 of 5 (456 Views)

Re: Alternate Units on Hole notes.

10-26-2012 06:24 AM in reply to: shastu

Edit the hole note (or change the style if it applies to the whole drawing) and uncheck the Part Units checkbox under Options.  Your model is apparently in inches, so by default that's what shows in hole notes.  Uncheck that, and it will use what your drawing style calls for.

Distinguished Contributor
shastu
Posts: 1,802
Registered: ‎12-10-2003
Message 5 of 5 (429 Views)

Re: Alternate Units on Hole notes.

10-29-2012 06:30 AM in reply to: shastu

Thanks

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.