Inventor Fusion

Distinguished Contributor
Posts: 173
Registered: ‎09-25-2008
Message 1 of 2 (101 Views)

need some refresher instructions on sweeping

101 Views, 1 Replies
03-21-2012 08:10 AM
its been a few years since i used inventor, so im messing with fusion right now till i get back in the groove before i buy inventor when sweeping, i made a circle sketch on top plane. then i made a spline on the front plane starting from the center of the circle on the top plane two different sketches, two different planes. but it wont let me sweep, i need to peirce the plane... how do i make the spline peirce the plane?
*Expert Elite*
Posts: 25,253
Registered: ‎04-20-2006
Message 2 of 2 (100 Views)

Re: need some refresher instructions on sweeping

03-21-2012 08:19 AM in reply to: andrew.nao

andrew.nao wrote:
.... but it wont let me sweep, i

Attach the file here.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2014 Edu 64-bit

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor