Inventor Fusion

Posts: 22
Registered: ‎07-22-2009
Message 1 of 3 (172 Views)


172 Views, 2 Replies
07-24-2009 06:53 PM
I cant seem to sweep a sketched line (x,y) along a curved path (x,z) to create a concave/convex work plane/surface as in previous versions. Which I might then project geometry onto. Edited by: Mattaxe on Jul 25, 2009 2:13 AM
Posts: 66
Registered: ‎08-28-2006
Message 2 of 3 (172 Views)

Re: Sweep?

07-25-2009 11:18 AM in reply to: Mattaxe
Currently, Fusion does not support surface modeling at all. Only solids are supported.

Thanks for the feedback

Jeff Strater (Fusion development team)
Posts: 22
Registered: ‎07-22-2009
Message 3 of 3 (172 Views)

Re: Sweep?

07-25-2009 08:11 PM in reply to: Mattaxe
OK...... except I was trying to create a customized work plane of the "Translucent type". (but yes I think its called a surface in Inventor 2008).

Looking forward to full functionality.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor