Inventor Fusion

Reply
Contributor
Mattaxe
Posts: 22
Registered: ‎07-22-2009
Message 1 of 3 (181 Views)

Sweep?

181 Views, 2 Replies
07-24-2009 06:53 PM
I cant seem to sweep a sketched line (x,y) along a curved path (x,z) to create a concave/convex work plane/surface as in previous versions. Which I might then project geometry onto. Edited by: Mattaxe on Jul 25, 2009 2:13 AM
Employee
jeff.strater
Posts: 82
Registered: ‎08-28-2006
Message 2 of 3 (181 Views)

Re: Sweep?

07-25-2009 11:18 AM in reply to: Mattaxe
Currently, Fusion does not support surface modeling at all. Only solids are supported.

Thanks for the feedback

Jeff Strater (Fusion development team)
Contributor
Mattaxe
Posts: 22
Registered: ‎07-22-2009
Message 3 of 3 (181 Views)

Re: Sweep?

07-25-2009 08:11 PM in reply to: Mattaxe
OK...... except I was trying to create a customized work plane of the "Translucent type". (but yes I think its called a surface in Inventor 2008).

Looking forward to full functionality.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.