Inventor Fusion

New Member
Posts: 1
Registered: ‎12-16-2012
Message 1 of 2 (228 Views)

Inventor fusion installation failure

228 Views, 1 Replies
12-16-2012 01:38 PM

I am having trouble installing inventor fusion. I have installed and autocad will open but when I try to open fusion splash screen opens, then i get a notification that there was an error while initializing the graphics subsystem. it says that it could be from the graphics driver not being configured to true color. As far as I can tell it is, but I am not sure. any help I can get would be greatly appreciated!!! Thanks

Posts: 90
Registered: ‎05-26-2008
Message 2 of 2 (222 Views)

Re: Inventor fusion installation failure

12-16-2012 06:11 PM in reply to: kyliecummings14

Would you please check if  the version of your graphic driver is the latest. If not, please upgrade to the latest version and then launch again.



Macro Liu

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor