Inventor Fusion

*Expert Elite*
Posts: 4,149
Registered: ‎04-27-2005
Message 1 of 2 (132 Views)

Intersecting Surface - Best Practice

132 Views, 1 Replies
08-23-2013 11:16 AM

I brought a part in fom Inventor.  When I do a Validate, I have an intersecting surface. Normally I would just delete the intersecting surface and then patch it back in.  Here, if I just delete the intersecting surface, I will loose part of the profile of the part becaused it is on an edge.


 What is the best/easiest way to take care of this in Fusion? 



Board Manager
Posts: 264
Registered: ‎06-29-2012
Message 2 of 2 (122 Views)

Re: Intersecting Surface - Best Practice

08-26-2013 12:30 PM in reply to: karthur1

Have you tried to trim the intersecting surfaces?

Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor