Inventor Fusion

Reply
Active Contributor
Posts: 34
Registered: ‎02-14-2013
Message 1 of 4 (301 Views)

Combining components for export/print

301 Views, 3 Replies
02-14-2013 06:35 AM

Full disclosure, I'm completely new to 3D design and I've spent a couple of weeks figuring out the right tools and learning some of the basics.  Now that the OSX crash is behind us, I can actually save and load files. :smileyhappy:

 

My problem is that when I export the attached model as STL, ReplicatorG only sees the main body and does not see the cavity and entry point for the latching mechanism.  When loading the STL back into IF, the entire object is there.  So, I presume the problem to be in ReplicatorG but my simple workaround is to combine four components into one body and export that way.  I've spent about an hour trying different things and searching the internet/forums and can't figure this out.

 

Ack! Any advice would be very much appreciated.

Active Contributor
Posts: 34
Registered: ‎02-14-2013
Message 2 of 4 (291 Views)

Re: Combining components for export/print

02-14-2013 10:57 AM in reply to: LeonMF

I have a workaround.

 

  1. Export as STL
  2. Load into FreeCad
  3. Export as STL
  4. Load with ReplicatorG

I'll test the build tonight when I get home.

Board Manager
schneik
Posts: 587
Registered: ‎04-05-2003
Message 3 of 4 (287 Views)

Re: Combining components for export/print

02-14-2013 12:51 PM in reply to: LeonMF

Try using gmesh to open the stl and then save as STL binary. This is something we are looking into.

 

Kevin Schneider


15" Macbook Pro Retina - OSX 10.9 in Portland, Oregon


Active Contributor
Posts: 34
Registered: ‎02-14-2013
Message 4 of 4 (280 Views)

Re: Combining components for export/print

02-14-2013 10:11 PM in reply to: LeonMF

Actually, I was a bit wrong earlier.  To get it to work I had to do the following:

 

  1. Export as SAT from Inventor Fusion
  2. Open SAT in IF and export as STL
  3. Open STL in Freecad
  4. Save as native in Freecad
  5. Export from Freecad as STL

The print came out fine with some odd printing artifacts around the joints that probably shouldn't be there.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube