Inventor Engineer-to-Order

Posts: 15
Registered: ‎09-14-2011
Message 1 of 2 (67 Views)

Using ETO Studio against AutoCAD

67 Views, 1 Replies
01-24-2013 06:01 AM

For one of my applications I am using ETO against AutoCAD. Is it possible to use ETO Studio against AutoCAD or is it just Inventor?

Posts: 189
Registered: ‎03-06-2006
Message 2 of 2 (63 Views)

Re: Using ETO Studio against AutoCAD

01-24-2013 07:22 AM in reply to: csuffell

Currently, there is no "debug" connection between ETO Studio and anything other than Inventor.  Getting this connection right is one of the hardest problems in supporting a debugger.  However, you can use ETO Studio to edit and work with libraries that are host indepedent, and you can of course use the editor for host-dependent stuff.  Since Studio runs an Intent kernel to compile source when there is no connection, you will get some of the benefits.


In addtion, Inventor now supports many of the original ISL (Intent Standard Library) primitives, so you can actually use Inventor to run rules restricted to these.


--Jack Gregory


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor