Inventor Engineer-to-Order

Reply
Board Manager
sanjay.ramaswamy
Posts: 109
Registered: ‎11-13-2007
Message 1 of 4 (352 Views)

ETO Potlatch Presentations

352 Views, 3 Replies
10-17-2012 05:02 PM

The presentations from the previous two Potlatch webinars are attached.

 

If you're not on the webinar invite list and would like to be included, send me an email at sanjayDOTramaswamyATautodeskDOTcom

 

Sanjay-

Mentor
bsee1
Posts: 211
Registered: ‎11-14-2011
Message 2 of 4 (248 Views)

Re: ETO Potlatch Presentations

12-27-2012 10:51 AM in reply to: sanjay.ramaswamy

The potlatch videos are great.  I have 2 requests. 

 

Can you make a webpage on the wiki, and keep it updated with these videos, so we don't have to dig through the forum everytime we want a link?

 

This one is a bit more important.  Can you give the option to download these files rather than stream?  I don't know if it's my internet, or your hosting, but the videos always stutter, repeatadly need to buffer, or just flat out stop streaming in the middle.  I'm currently trying to watch volume 4.  While it was working I had no video.  Then the whole thing stopped streaming.

 

I have the proper codec, and I can sometimes(but very rarely) make video and sound work properly.

*****************************
Win7 x64 - 16gb ram
i7 3610qm
FirePro M4000

Inventor 2013
ETO 6.1
Mentor
bsee1
Posts: 211
Registered: ‎11-14-2011
Message 3 of 4 (241 Views)

Re: ETO Potlatch Presentations

12-27-2012 11:12 AM in reply to: bsee1

As an update to that, I finally got streaming to work for volume 4, but it only shows the static cover image through the entire video.  Without video, I'm not sure this volume will be much use.  Again, I don't know if it's just having problems streaming, or if it was a technical difficulty when recording.

 

 

*****************************
Win7 x64 - 16gb ram
i7 3610qm
FirePro M4000

Inventor 2013
ETO 6.1
Board Manager
sanjay.ramaswamy
Posts: 109
Registered: ‎11-13-2007
Message 4 of 4 (163 Views)

Re: ETO Potlatch Presentations

01-16-2013 12:54 PM in reply to: bsee1

Watch this blog for postings of the Potlatch videos:

 

http://modthemachine.typepad.com/

 

Sanjay-

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Inventor Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for Autodesk Inventor helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Inventor

Twitter

Facebook

Blogs

Pinterest

Youtube