Installation & Licensing

New Member
Posts: 1
Registered: ‎08-11-2013
Message 1 of 2 (106 Views)

Transfer License 2007 LT using PLU

106 Views, 1 Replies
08-11-2013 08:21 PM

--how get number of target computer?  Load on target PC and open PLU?

Do I load the 2007 program on the target computer and open PLU?  After loading, will I be able to open the PLU?

*Expert Elite*
Posts: 10,042
Registered: ‎01-14-2005
Message 2 of 2 (87 Views)

Re: Transfer License 2007 LT using PLU

08-12-2013 07:44 AM in reply to: goetzinger

Welcome to the community.


You can attempt this if you want.  However, the PLU works aboout -1 times out of 10.  :smileyvery-happy:


If your license is still valid (meaning it was never upgraded, cross-graded, or under expired Subscription) then you should be able to just install it on the new workstation and activate it over the Internet.  If you need a manual activation you can do so.  It's way better than messing with the PLU. 


You can use the online method to activate your license here:

Good Luck!

Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Up & Ready Blog

Boldly Install, Configure and Deploy Autodesk Software.

AutodeskHelp Blog

Your one-stop shop for the latest solutions, breaking news, and behind the scenes access to the world of Autodesk support.

Connect with Us