Installation & Licensing

Reply
Active Member
Posts: 6
Registered: ‎06-23-2006
Message 1 of 2 (636 Views)
Accepted Solution

Network Licence To Standalone Licence Transfer

636 Views, 1 Replies
12-03-2012 09:14 AM

Hi,

 

We have a network license of AutoCAD 2013 installed on a couple of machines, due to the conflict in a standalone install of Fabrication CADmep 2013 we need to move the AutoCAD 2013 license from Network to Standalone. We have the standalone license number and product codes. We just need to understand if we have to uninstall the network autoCAD and re install or is it possible to assign the standalone license number to the current install.

 

Regards

 

WillieR

 

*Expert Elite*
TravisNave
Posts: 9,515
Registered: ‎01-14-2005
Message 2 of 2 (628 Views)

Re: Network Licence To Standalone Licence Transfer

12-03-2012 01:59 PM in reply to: warobertson

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with Us

Twitter

Pinterest

Blog

Youtube