Installation & Licensing

Reply
Distinguished Contributor
Posts: 165
Registered: ‎01-26-2004
Message 1 of 2 (379 Views)
Accepted Solution

Multipel Error 1406 errors trying to install Inventor

379 Views, 1 Replies
12-23-2012 09:38 AM

During re-installation of Inventor 10 I get many errors 1406 not being able to write to e.g. \EnableFullPage\.swf and many others. This is the first time i have gotten this and I am at a loss. I have tried to change permissions in the Registry, but I am getting nowhere. Does irt have perhaps to do with the fact that I am installing on drive F:\ and not C:\ (not enough room - small solid state) 

*Expert Elite*
TravisNave
Posts: 9,538
Registered: ‎01-14-2005
Message 2 of 2 (339 Views)

Re: Multipel Error 1406 errors trying to install Inventor

12-26-2012 11:11 AM in reply to: dknaggert

That's an old *known* error back in the day for Macromedia Flash player.  You can safely hit IGNORE on about a dozen of those error messages and your Inventor will install.  Then I would recommend that you go to http://www.flash.com and update your Flash player to the latest version.  You should be good to go.

 

Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with Us

Twitter

Pinterest

Blog

Youtube