Installation & Licensing

Reply
Contributor
ggaska
Posts: 23
Registered: ‎11-01-2001
Message 1 of 3 (145 Views)

FLEXlm NT service not starting

145 Views, 2 Replies
10-12-2001 12:04 AM
I get the following error:
"The FLEXlm Service 1 service failed to start due to the following error: %1 is not a valid Windows NT application."
This is after i stopped the service once before and was never able to restart it again. I uninstalled, regcleaned and reinstalled, but am still getting the same error. Please help...anyone.
-gint
Contributor
ggaska
Posts: 23
Registered: ‎11-01-2001
Message 2 of 3 (145 Views)

Re: FLEXlm NT service not starting

10-12-2001 01:28 AM in reply to: ggaska
...a bit more info: if i attempt to start the service in Control Panel, i get the following: "Could not start the FLEXlm Service 1 service on \\GW9751543. Error 0193: %1 is not a vaild Windows NT application." In LMTools, when 'preforming a check sum' on my license, the response is: 'checksum'. Is this the correct response?
Contributor
ggaska
Posts: 23
Registered: ‎11-01-2001
Message 3 of 3 (145 Views)

Re:

10-12-2001 06:08 AM in reply to: ggaska
...forget it...i'm starting over...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Up & Ready Blog

Boldly Install, Configure and Deploy Autodesk Software.

AutodeskHelp Blog

Your one-stop shop for the latest solutions, breaking news, and behind the scenes access to the world of Autodesk support.

Connect with Us

Twitter

Pinterest

Blog

Youtube