Community
Installation & Licensing
Welcome to Autodesk’s Installation and Licensing Forums. Share your knowledge, ask questions, and explore popular Download, Installation, and Licensing topics.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

32 Bit Inventor Pro Install and Download Questions

2 REPLIES 2
Back to Subscription, Installation and Licensing Category
Back to Topic Listing
Reply
Message 1 of 3
djl2129
Community Visitor
533 Views, 2 Replies
‎03-28-2012 04:34 AM
‎03-28-2012 04:34 AM

32 Bit Inventor Pro Install and Download Questions

Hello,   I have a older 32 bit machine,   there are 3 file downloads for Inventor Pro 2011,   the first is an exe, the next 2 are  zipped .rar files.

 

How do I proceed in installing after downloading these 3 files  ?   Do the other two  .rar files need unzipped first,  or do you just run the .exe  ?   

 

any help on installing these 3 files onto  32 bit machine is appreciated.

 

thanks

-derek luff

Virginia community colleges

Report
0 Likes
Reply
2 REPLIES 2
Message 2 of 3
TravisNave
Mentor
in reply to: djl2129
‎03-28-2012 01:18 PM
‎03-28-2012 01:18 PM

No, the first .exe file will self-extract the other two automatically.  They will extract into a folder and then you can run setup from there.  Make sure you have local admin rights, UAC is off, and anti-virus is disabled.  Good luck!



Travis Nave Send TravisNave a Private Message                                             Need help in your post? Mention me with @TravisNave



My Expert Contributions to the
Autodesk Forums:
FLEXnet License Admin | MSI Cleanup Utility | .NET Framework Cleanup Tool | IPv6 NLM Fix | adskflex.opt Options File | Combine .LIC Files
Disk Space | Quickstart Guide for LMTOOLS | Edit setup.ini for 1603 Installation Failure | 1603 Error installing /w Updates | Disable Optimus
⤽   If my post was helpful, please give Likes and/or mark the Accept as Solution button(s) below. Thank you!   ⤵
Report
0 Likes
Reply
Message 3 of 3
djl2129
Community Visitor
in reply to: TravisNave
‎03-30-2012 04:14 PM
‎03-30-2012 04:14 PM

thank you much,  I will follow that protocol.

 

Report
0 Likes
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Administrator Productivity


Autodesk Design & Make Report

Report a website issue