InfraWorks General

Reply
Active Member
Posts: 10
Registered: ‎08-22-2006
Message 1 of 3 (490 Views)

Ground Imagery Over Exposed

490 Views, 2 Replies
10-02-2012 06:31 AM

I have been experiencing this problem for quite some time and I cannot seem to find a way to resolve it. Hopefully someone will have a suggestion. When I import Ground Imagery, the contrast is often way too intense as if the image is over exposed or a contrast and brightness filter were applied improperly. I checked the image in Photoshop and the brightest areas are well below 255.255.255 RGB white. I would almost say that some shader is parcing the images wrong for the viewport. Has anyone else experienced this issue? Anyone found a way around it?</

Mark Kauffman
Project Visualization
Parsons Brinckerhoff, Inc.
*Expert Elite*
TRogers
Posts: 1,133
Registered: ‎09-05-2007
Message 2 of 3 (486 Views)

Re: Ground Imagery Over Exposed

10-02-2012 09:05 AM in reply to: kauffman

See my post at the link below and see if that helps....

 

http://forums.autodesk.com/t5/Autodesk-Infrastructure-Modeler/Odd-Image-Display/td-p/3604230

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Active Member
Posts: 10
Registered: ‎08-22-2006
Message 3 of 3 (482 Views)

Re: Ground Imagery Over Exposed

10-02-2012 09:22 AM in reply to: TRogers

That's a negative. The image only appears to have the 3 color channels and not a 4th. My imagery is defaulting to a band mapping type of RGB. As a test to see what would happen, I switched to Gray and set band #1: red as the type. I get a grayscale image for the aerial as expected, but the white are completely blow out as before. Again, it is as if AIM is applying a contrast and brightness filter to the image.

Mark Kauffman
Project Visualization
Parsons Brinckerhoff, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community