Impression

Reply
Member
cadman1966
Posts: 3
Registered: ‎07-21-2008
Message 1 of 5 (1,199 Views)

Program crash with Impression 2

1199 Views, 4 Replies
04-19-2010 04:17 AM
If I want to open each dwg file with impression 2 there every time the program crash. What can be the cause?

Please help me!
Valued Contributor
Jim_Earle
Posts: 62
Registered: ‎11-14-2007
Message 2 of 5 (1,107 Views)

Re: Program crash with Impression 2

08-11-2010 11:32 AM in reply to: cadman1966

seems like I remember a problem like this and the reason was not enough memory. Obviosuly if you have more than enoguh then its a differnt reason. If you can try it on another computer that would rule out a bad file. You may try re-installing impressions as well or give version 3 a shot.

Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 3 of 5 (862 Views)

Re: Program crash with Impression 2

01-26-2011 01:10 PM in reply to: Jim_Earle

Yikes, crashing on a system with 8gb ram here! Tried it on another with 12gb ram, same result. Trying version 3 now.

Valued Contributor
TexShalter
Posts: 75
Registered: ‎06-18-2010
Message 4 of 5 (825 Views)

Re: Program crash with Impression 2

02-03-2011 02:21 PM in reply to: c.leitch
Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 5 of 5 (823 Views)

Re: Program crash with Impression 2

02-03-2011 02:42 PM in reply to: cadman1966

Thank you so much, I had not seen the SP. FWIW working fine on version 3.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community