Active Member
Posts: 6
Registered: ‎04-15-2003
Message 11 of 14 (159 Views)

Re: Memory Error

01-24-2007 05:58 PM in reply to: TerribleTim68
Ah, not supporting 64 bit. This explains failure to launch. I have 64 bit Windows XP Professional. You'd think the 'system requirements tester' would have picked that up.
Active Contributor
Posts: 26
Registered: ‎11-14-2006
Message 12 of 14 (159 Views)

Re: Memory Error

02-14-2007 02:43 PM in reply to: TerribleTim68
We just posted Impression Technology Preview 4 this morning:

This version has some improvements that should reduce the out of memory conditions.

We also save a recovery file if we need to close due to low memory conditions.
Active Member
Posts: 10
Registered: ‎12-05-2006
Message 13 of 14 (159 Views)

Re: Memory Error

03-05-2007 03:59 PM in reply to: TerribleTim68
Using 4, I get this message quite a bit, usually with fills, blocks and printing.
Active Contributor
Posts: 28
Registered: ‎09-27-2004
Message 14 of 14 (159 Views)

Re: Memory Error

03-08-2007 10:34 AM in reply to: TerribleTim68
using 4 and ran into this today also.
any tips on how to avoid this error?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community