Re: new loft tool design time line is flawed already when released - Autodesk Community

Community

Forums

Fusion Design, Validate & Document

Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.

Reply

Message 1 of 3

253 Views, 2 Replies

loft already seems to have some serious issues. Here I just loft two cylinders. fusion gives me a good preview and the bugs out when it comes to accepting the tool option - rendering this dead on arrivale.

and this is what I get back:

Claas Kuhnen

Faculty Industrial Design – Wayne State Universit

Chair Interior Design – Wayne State University

Owner studioKuhnen – product : interface : design

2 REPLIES 2

Message 2 of 3

We discovered this yesterday and debated holding the update till we could figure out what was going on. We decided not to hold up the update for it but looking into whats going on. We hope to have an update very soon.

Sorry for the inconvenience.

Message 3 of 3

Hey Garin,

Thank you for confirming that this is a bug.

Claas

Claas Kuhnen

Faculty Industrial Design – Wayne State Universit

Chair Interior Design – Wayne State University

Owner studioKuhnen – product : interface : design

Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums