Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

driver not recognized

1 REPLY 1
Reply
Message 1 of 2
trudyfreestyle
166 Views, 1 Reply

driver not recognized

yesterday when trying to plot i received the following message;

this plotter configuration cannot be used for one of the foloowing reasons, the driver cannot be found, the device cannot be found or the driver has a problem. The none plot device has been subsituted.

I can print and make pdf;s no problem in other programs.

Thanks!

 

1 REPLY 1
Message 2 of 2

Thank you for posting. What commands are you using in Fusion 360, Capture Image? 

 

capture image.png

 

I see a Print in the Item Details page, is this the command you are using (See below image)? 

Print.png

 

Which PDF Printer are you using? Have you tested any others?

 

Thanks,

 

 




Nathan Chandler
Principal Specialist

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report