Flame Forum
Welcome to Autodesk’s Flame Family (Flame, Flare, Flame Assist, Lustre) Forums. Share your knowledge, ask questions, and explore popular Flame topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Text node bug when using AA

5 REPLIES 5
Reply
Message 1 of 6
HalloweenJack2
505 Views, 5 Replies

Text node bug when using AA

Hi folks,

 

I'm still running 2013 20AE.

 

That incredibly annoying bug in the text node in batch which causes frequent corruption when using anything except Auto-Softness...

 

Has it been fixed yet?

 

Cheers

5 REPLIES 5
Message 2 of 6

Hi.

 

It was not fixed in any released version up to (and including) 2014 SP2.

I have added your name to the list of users affected and will post an update when this is fixed.

 

Regards,

Robert.



Robert Adam
Program Manager

Message 3 of 6

Sad news 😞

Message 4 of 6

Apologies for not being able to share good news right now.

 

Regards,

Robert.



Robert Adam
Program Manager

Message 5 of 6
ManChicken
in reply to: HalloweenJack2

I think I've run into this as well... it corrupts the entire output, not just the Text node, right?

I was building a slate template yesterday and out of nowhere the entire image blew up and had purple dots all over it...

Bob Maple | idolum
Message 6 of 6
HalloweenJack2
in reply to: ManChicken

Yep the whole output.

 

You have to continually disconnect it and swap between 16bit and 8bit and hope it stays away long enough to render.

 

I was forced to let a few jobs go out with auto softness and hope no-one noticed. There were 8 text nodes and I simply didn't have the time to keep reconnecting them as I'm usually forced to do.

 

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report