Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fusion 360 training/getting started videos

2 REPLIES 2
Reply
Message 1 of 3
herzinj
242 Views, 2 Replies

Fusion 360 training/getting started videos

Hi folks,

 

If you get a chance, could you take a look at one or two of the videos in the playlist below?  I'm curious if you think this type of very simple video break down would have been helpful (or would be helpful) for you while you were learning Fusion 360.  These are a few videos in a series I started a while back, and now after repeated requests for more documentation, training and getting started content, I think there might be a place for something like this.  I am trying to keep it very simple and searchable.  Please let me know what you think!

 

https://www.youtube.com/playlist?list=PLHIAsG4oQktExFxGPbCRl4DJz7IbipnBT

 

Thanks,

 

James

https://damassets.autodesk.net/content/dam/autodesk/logos/autodesk-logo-primary-rgb-black-small_forum.png
2 REPLIES 2
Message 2 of 3
rishivadher
in reply to: herzinj

Hi James
I may be useful for someone, but if it’s the persons first time in to CAD then what will happen if the Fusion 360 interface changes as it changes on its updates.
Best Rishi

Message 3 of 3
herzinj
in reply to: rishivadher

Thanks for the feedback Rishi.  I was thinking the same thing but thought perhaps having something is better than nothing.  Barring a HUGE design change, most videos should still be able to be understood.  This would definitly be a concern though.

 

Thanks!

 

James

https://damassets.autodesk.net/content/dam/autodesk/logos/autodesk-logo-primary-rgb-black-small_forum.png

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report