Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Anyone going to...?

3 REPLIES 3
Reply
Message 1 of 4
schneik-adsk
362 Views, 3 Replies

Anyone going to...?

http://www.develop3dlive.com

 

Let us know. A few of us will be there and I bet Carl Bass might have a few words to say about Fusion 360.

Kevin Schneider
3 REPLIES 3
Message 2 of 4
mark.young
in reply to: schneik-adsk

Hey Kevin, I will be heading up there tomorrow.

I will have something straight off my 3d printer too, if it's built OK 🙂

Message 3 of 4

Too bad its not online as well, I would attend.  Digital drinks are fine

Message 4 of 4
schneik-adsk
in reply to: mark.young

Sorry I missed you. I did get to see the pictures.

Kevin Schneider

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report