Fillet with a 0 radius

[CGPM]

It would be nice if fillet radius would accept 0 so it could be used to clean up imported sketches.  It is a great way to make the ends of two lines match.

[HughesTooling]

There's a sort of solution given here, using a coincident constrain.

http://forums.autodesk.com/t5/inventor-general-discussion/fillet-radius-0/m-p/2905274#M393973

The only problem, it tends to move one of the lines if they're not constrained first.

Mark.

[TimeraAutodesk]

Thank you for idea - this is getting archived due to lack of votes. If you feel strongly that this is needed, please resubmit with more detail on why you think this is valuable to Fusion 360 users so that the idea gathers some more support from the community.