2 Kudos
Light_Guy

Unite the UCS's

Status: Under Review
by Distinguished Contributor Light_Guy on ‎12-17-2012 05:40 AM

Why does the FDS layout have a different UCS than standard Inventor files? It makes for some frustrating moments when inserting non-asset part files. It's not that it causes problems, its just annoying!

Status: Under Review
Comments
by Employee mike.jolicoeur on ‎02-04-2013 08:28 AM
Status changed to: Under Review
 
by Employee mike.jolicoeur on ‎02-04-2013 08:29 AM

Can you give me a little bit more information on this?  I'd like to see what we can do with it but I am not sure I fully understand the issue.  Thanks!

by Distinguished Contributor Light_Guy on ‎02-04-2013 09:10 AM
Mike - I sent you a couple of pix in Private Message of the differences in UCS between a regular Inventor Part and a standard FDS layout. You will notice that the views are the same as determined by the ViewCube in each but the UCS is off by 90 degrees on the X axis. When inserting standard parts or assemblies (not assets) they come in with that 90 degree discrepancy. This also goes for inserting things like point clouds as well and getting those rotated is a REAL pain.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
IdeaStation Guidelines
Review guidelines and best practices
before posting a new idea