Dynamic Blocks

Reply
Contributor
sylvain_c
Posts: 17
Registered: ‎03-22-2010
Message 1 of 2 (276 Views)
Accepted Solution

Flipping a Logo within a block, without mirroring it.

276 Views, 1 Replies
10-26-2011 11:30 AM

I'm trying to make a Dynamic Block for handicap parking spaces (attached).

 

I have a flip action so that I can switch the direction of the linear array.  The problem is when I flip the block, the handicap logo is mirrored (obviously....).

 

Is there a way to mirror just the location of the logo, instead of mirroring the location AND the logo?

 

Would it be possible to make a block with the handicap logo and lock the X scale value to 1 ?...

 

Any help would be appreciated... worst comes to worst, i'll remove the flip action and replace it with a rotate action.

 

Thanks.

Valued Contributor
jason.estas
Posts: 86
Registered: ‎01-08-2009
Message 2 of 2 (268 Views)

Re: Flipping a Logo within a block, without mirroring it.

10-26-2011 03:16 PM in reply to: sylvain_c

G'day,

 

Please refer to attached DWG.

 

As you may notice there is a move command on the disabled symbol. When using the flip command instead of selecting the disabled symbol, select the move parameter instead. This will stop the symbol from mirroring.

 

Jason

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community