no update view, no viewbase, no viewsection anymore Autocad2013

[Jelle64]

I made a 3D model in Autocad2013 and on the lay-out I made a viewbase and viewsections. Everything went well but after a while I had to change something and the command  ‘update view’ don’t work anymore. So I tried the commands viewbase, viewsection,… none of them act normal. By viewsection I can select a view but 1 found, 1 filtered.

I tried another old drawing and everthing went well.

I even restart my PC. No result.

How can I solve this problem?

Thanks

[Bob_Zurunkle]

I nothing else, you could try starting a new drawing, then copybase model and viewports into it one by one to see if it works, or when it breaks etc...

[Jelle64]

My model is still ok

I can copy it to a new drawing, but then start the job to make the drawing nice, change hatch, dimensions, levels, groundlevel, exra text,  .... a lot of work. And I will loose all of this.

I don't use viewports anymore.

I have to present a 2D of my 3D so I use viewbase, viewsection,...

[sbekkers]

I have had the same problem, sometimes the views go berserk!

Sometimes they will restore after a shut down and restart.

It seems once the view is broken they need to be redone?

[Jelle64]

Sometimes they restore after a new "viewbase" and delete it later, but this
time nothing, not even after a restart of my PC.
I put my model on a new drawing, but first I made a contour on my lay-out
of the top view, draw where my section were, put recognition on the
section. So I could copy everything on the lay-out ( fe dim, text,
groundlevel, waterlevel, legend, note,...) and could reuse again, less
work. I hope Autodesk will solve this problem.