Design Review

*Expert Elite*
Posts: 2,832
Registered: ‎04-06-2010
Message 1 of 1 (117 Views)

Vault Visualizations 2013

117 Views, 0 Replies
06-18-2012 04:36 AM

Kudos to the development team for getting some dynamic stamps into the 2013 DR product.  Very nice.  Now.... why can we not check DWF files into or out of Vault?


Specifically what I would like is this:  When Vault creates a visualization file for an item, I can right click and select "Open in Design Review".  But I cannot make a change or markup... or add that nice new stamp... and then put it BACK into the Vault as the visualization file.  The whole point of asking for the stamps was so that our visualizations could be stamped by the approving engineer and then seen by users all over the plant through the Vault web client.


We're so close... just one more step and we'll be there!



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community