DWG TrueView

New Member
Posts: 1
Registered: ‎05-03-2011
Message 1 of 1 (327 Views)

TruView Measurement question

327 Views, 0 Replies
05-03-2011 08:18 AM

Good day,


I am currently trying to use the measure tool to get critical dimensions.  The document has been created using metric (mm) units and I have confirmed that it has been saved as a metric file.  However, the dimension tool on TruView is outputting imperial units.  I did not have a problem with that when TruView was giving me decimal dimensions (.5 for half an inch) as I could easily convert but TruView has recently decided that fractions would be the optimal way to go (1/2 instead of .5).  This does me no good at all and pretty much makes this program worthless.  I have once again verified that the document is being saved with all properties set to metric.  Can someone please help me figure out how to either: 1. get the measure tool to give me metric dimensions...or 2. get TruView to once again give me decimal imperial dimensions?


Thank you 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community