DWG TrueView

[#1]

I am opening a drawing with DWG TureView, the drawing opens, although the DAYSTAMP does not correctly show information, all I get is the red box with diagonal lines.

The attached dwf shows the DAYSTAMP in the upper left corner of the page.

Please help.

Thanks

[#2]

What created the "daystamp"?

[#3]

AUTOCAD??? what do you mean what created it?

its the standard DAYSTAMP and its being used in 2007, 2008, 2009, 2010 autocad, and civil 3d.

[#4]

if I plot it out of autocad to a dwf file then all works great, but if I use DWG Trueview, or Design Review, the stamp shows as seen on the attachedment.

[#5]

There is no DAYSTAMP command in AutoCAD: so you either used a FIELD,or PLOTSTAMP command or the old classic Express Tool RTEXT, or a third party add-on?

[#6]

Classic misunderstanding. The block "DAYSTAMP", old school block used to display the drawing plot time, date, file location, etc......

Its a AutoLisp routine, display correctly in all format drawings, although as shown on the attached drawing, does not show correctly in DWG Trueview.

Maybe I need to resvae the block in a newer format to be able to have the display of the stamp work correctly, I will try a few different ways.

Thanks for the help.

[#7]

What are the object types used? That's where it's failing, and why. The object type is not supported in the viewer.

[#8]

My bad, RTEXT

[#9 · Accepted solution]

LOL, Express Tools must be loaded to see their custom objects: since you cannot install ET in the viewer... no objects, just a box.

You folks should get into FIELD command in AutoCAD, or PLOTSTAMP as a minimum.

[#10]

Its hard enough trying to get users to remember to have plot stamp on, thus the daystamp. I will investigate the FIELD command.

THanks again.