Community
Mudbox Forum
Welcome to Autodesk’s Mudbox Forums. Share your knowledge, ask questions, and explore popular Mudbox topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Levels after retopology (mudbox 2015)

2 REPLIES 2
Reply
Message 1 of 3
p3dr084
1651 Views, 2 Replies

Levels after retopology (mudbox 2015)

Hello there

I'm quite new to mudbox and here comes my first issue..

 

Once I retopologize any sculpted object I'm not able anymore to navigate through levels..

I can see my levels are there.. but when I hit pgUP or pgDOWN this pops up: "You cannot go down from a level if it was created using different Smooth Positions value"

What I do wrong?

I'm watching many tutorials about it and I really do the same steps. Any program feature I should check?? 

 

Thanks a lot guys..

 

2 REPLIES 2
Message 2 of 3
absoluteKelvin
in reply to: p3dr084

try going into add new subdivision level options. if smooth positions is off. check it on. Then try to step down the levels again.
https://www.artstation.com/kelvintam
Message 3 of 3
p3dr084
in reply to: absoluteKelvin

yee that was the point 🙂

thank you!!

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report