Autodesk Utility Design

[#1]

Me again, hey does any body know why my line lengths are wrong in AUD? If I list a line using the "LIST" command the length is correct, when I use the "AUDINFO" command the lengths are incorrect. For expample I just listed an underground primary line that measures 134.78 Meters using the standard "LIST" command. When I use AUDINFO I get a measurement of 5586. Any help would be great!

Thanks in advance.

[#2]

After some more digging I have discovered that the measurements are off by exactly 40....Please help.

[#3]

I have figured out more of my problem but not all...when I invoke the UDSDWGSTAT command I get this result:

The scale of this drawing is 40 and model number 0.

I need to know the command to change the 40 to a 1...Anyone?

Thanks

[#4]

AUDINFO calculates additional wire length based on the connected structure, and the value set in configuration.
Make a note of the structure connected to the wire, then look in the configuration:
AUDCONFIG > Facilities > Structure
On the block name, "Additional Wire" will likely be 40.

[#5]

Well Heberpower,
Did this help?

Thanks Corn

[#6]

I figured ot out...Somehow SETVAR "useri1" was set to 40, changed it to 1 and everything is good now.

Thanks for all your help!

Heber Power