Autodesk Simulation Moldflow Insight
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Stress tensor calculatio
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
70 Views, 0 Replies
01-25-2013 12:24 AM
Hello,
Calculations with a Midplane mesh offer some results about a "stress tensor (warp)" but I could not find in the documentation what these stresses refer to. Could you help me ?
Best regards
Paul
