Autodesk Simulation Moldflow Adviser

[#1]

I have the Moldflow Plastics Adviser installed in Inventor as a drop-down
from Tools - Moldflow Plastics Advisers - Export to Plastics Advisers.

I believe I'm among very few (if not the only one) having this setup in my
region, as most users have the whole Moldflow package and not only the
Inventor integration.

How will this be affected in the future?

--

Peer
Iv2009 Sp1
Lenovo ThinkStation S10
Intel Core 2 Quad - 2.66GHZ
4GB RAM - WinXPSp3
Samsung SyncMaster 244T 24" 1920 x 1200
nVidia Quadro FX1700 - 512MB 6.14.11.6996
3Dconnexion SpaceNavigator 3.6.7

[#2]

Hello Peer,

The Autodesk Inventor integration (plug-in actually) will continue to be supported. As you may know, we have just announced the commercial release of Autodesk Moldflow 2010 products. The product previously known as, Moldflow Plastics Advisers has been renamed to, Autodesk Moldflow Adviser. We have also changed the release version number convention to follow the standard Autodesk release convention. Thus, the new product release number is "2010".

This new Autodesk Moldflow Adviser 2010 supports the Inventor plug-in.

If you have additional questions about the new release, please contact your local support team.

Thanks,

Murali Annareddy
Product Manager - Manufacturing Industry Group
Autodesk Inc.

[#3]

For a short while the autodesk.moldflowadvisor nntp-group was up and
running, and I submitted the OP question.
This group is now removed and can only be found on this web-forum that my local support team pointed out to me (thanks Berndt).

Will it be back again on the nntp-side?

--

Peer

[#4]

NNTP access is still available, but we needed to change the URL after your initial post (my fault for an embarassing typo). Here are the new URLs:



{color:#0000ff}news://discussion.autodesk.com/autodesk.moldflowadviser

{color}news://discussion.autodesk.com/autodesk.moldflowinsight





Eric Wright

Discussion Group Administrator

Autodesk, Inc.